【 Note for beginners 】 Instructions on how to install and maintain gear reduction motors:

1. Please confirm whether the appearance of the reducer motor is damaged before use? Is there any oil leakage?

2. Please confirm the voltage used for the reduction motor first. When the voltage is unstable, a voltage regulator can be installed.

3. Please confirm whether the purchased reducer motor specification is consistent with the Design specification?

4. Please confirm the fixed base to avoid looseness during transmission operation.

5. If accessories such as sprockets, pulleys, couplings, etc. are used, they must be installed in accordance with relevant regulations.

6. Special lubricating oil has been inserted into the gearbox body, and there is no need to change the lubricating oil after 12000 hours.

7. When the reducer motor is in operation, the rated current should not exceed the current value indicated on the motor nameplate.

8. Please pay attention to surrounding temperature, humidity, acidity, and alkalinity issues.

9. Suitable for environments ranging from -10 ° C to+40 ° C, with humidity below 90%, and indoor elevations below 1000 meters.

10. If not installed, maintained, or operated in the correct manner, it may cause serious injury to the reduction motor.

11. When repairing or disassembling, it is necessary to confirm that the external power supply is completely disconnected from the reducer motor.

12. Safety protection devices need to be installed to ensure absolute operational safety.

13. The motor needs to be grounded, please refer to the relevant power distribution regulations.

14. Please confirm that all installation components and transmission accessories are fixed correctly before starting the reduction motor.

15. If the reduction motor is combined with a frequency converter for low speed transmission, an independent auxiliary cooling fan needs to be installed.

16. After the single-phase deceleration motor is powered off, there is still some residual charge in its capacitor. Please discharge or ground the terminal first.